Martin, Larry D
2011-12-22 13:00:01 UTC
I am doing an install on an IBM Z9 LPAR of 6.0.3.
The install was going smoothly until I got to "Configure direct access
storage device". I supplied an address and was ask if I wanted to
format it; I said yes and when it finished it went back to the
previous screen. It just keeps alternating these screens.
In another session if I do # cat /proc/dasd/devices I get:
0.0.2249(ECKD) at ( 94: 0) is dasda : active at blocksize: 4096, 1803060 blocks, 7043 MB
0.0.224a(ECKD) at ( 94: 4) is dasdb : active at blocksize: 4096, 1803060 blocks, 7043 MB
How do I move forward?
Thanks, ...........Larry
Larry D. Martin
Mainframe Systems Support
Office of Information Technology and Communications
301.883.7335
The install was going smoothly until I got to "Configure direct access
storage device". I supplied an address and was ask if I wanted to
format it; I said yes and when it finished it went back to the
previous screen. It just keeps alternating these screens.
In another session if I do # cat /proc/dasd/devices I get:
0.0.2249(ECKD) at ( 94: 0) is dasda : active at blocksize: 4096, 1803060 blocks, 7043 MB
0.0.224a(ECKD) at ( 94: 4) is dasdb : active at blocksize: 4096, 1803060 blocks, 7043 MB
How do I move forward?
Thanks, ...........Larry
Larry D. Martin
Mainframe Systems Support
Office of Information Technology and Communications
301.883.7335